Find your size

As every piece of jewelry is handcrafted for you, make sure to choose the right size. To make it easier for you to find the best fit, we made a guide for you below.



If you don’t know your ring size, there are several options to find it out:

  • Use a ring sizer
  • If you already have a ring that has the right size, you can measure the inner diameter of the ring and use the size chart to know your size
  • If you don’t have a ring for reference, measure your finger by using a piece of paper or a thread and wrap it around. Measure the distance in millimeters – this is the circumference


Always make sure to measure your fingers when they are warm as fingers react to changes in temperature and therefore a variation of size can occur. It is better to measure your fingers at the end of the day for the best fit as fingers tend to be smaller early in the morning and in cold weather and expand in hot weather.

The width of the ring affects the size. Very thin rings are true to finger size. If the ring is wider, it needs a wider fit too.

If you are not sure about your finger sizes, better take one size up.


Average ring sizes for women are between 52-57 with 53-54 as the most common for right and left ring finger.

Average ring sizes for men are between 57-63 with 60-62 as the most common.



Our ring size chart starts from finger conference 38 for fingertips (midi) rings.


If you are unsure about your bracelet size, you can use either a piece of paper, a thread or a measuring tape and put it around your wrist to measure the circumference in mm.

You can add a little bit so the bracelet has a loose fit and doesn’t sit too tight around your wrist.


For a bangle:

  • Place your hand in the position of putting on a bangle.
  • Use your piece of paper, thread or measuring tape and measure around the widest part of your hand including your thumb knuckle



You can measure your anklet in the same way you did for your bracelet. When wrapping a thread around your ankle, don’t pull it too tight, add a little bit to it as it should sit loose because if you start walking your ankle expands.



Wrap a thread or a measuring tape around your belly and chose the place on your belly where you would like your chain to sit. Some people like to place their belly chain under their navel while others like to place them higher up, above the navel. Make sure not to pull the tape too tight or leave it too loose.



Either measure a necklace you already own or use a thread to find your preferred length. Some like to have their necklace sitting higher up than others.

For a choker style, chose a smaller size.